Rear

REMOVAL
1. Remove rear seat cushion.
2. Remove rear seat back.
3. Remove rear safety belt anchor bolt.
4. Remove quarter trim panel.
5. Remove push pin retaining rear safety belt retractor cover. Remove bezel and rear safety belt retractor cover.
6. Remove retractor anchor bolt and retractor screw.
7. Remove anchor end of rear safety belt through the opening in the quarter trim panel.
8. Remove outboard rear safety belt retractor and tongue from the vehicle.

INSTALLATION
1. To install, reverse Removal procedure.
2. Make sure the safety belt webbing is not twisted. If it is, remove the twist.
3. Tighten rear safety belt anchor-to-sill bolt and retractor anchor bolt to 30-40 Nm (22-30 lb-ft). Tighten retractor screw to 22-33 Nm (16-24 lb-ft).
4. Check the restraint system for proper operation.