Front Safety Belt

REMOVAL

NOTE: Seat Belt Bolt Bit T77L-2100A should be used for removal and installation of the safety belt bolts on all safety belt assemblies.

1. Remove front seat shoulder strap guide cover.
2. Insert Seat Belt Bolt Bit T77L-2100-A and remove front safety belt guide anchor bolt.
3. Remove safety belt anchor-to-sill bolt and rubber washer.
4. Remove rear door scuff plate/quarter trim panel retaining screws and panel.
5. Remove safety belt through slot in quarter trim panel.
6. Remove safety belt retractor bolt.
7. Remove outboard front safety belt retractor and tongue from vehicle.

Outboard Attachments:

INSTALLATION
1. To install, reverse the Removal procedure.
2. Make sure the safety belt webbing is not twisted. If it is, remove the twist.
3. Tighten all anchor bolts and retaining nuts to the required specification shown for each mounting position.
4. Check the restraint system for proper operation.