221-326
NOTEKOEO refers to Key On Engine Off (KOEO)
KOER refers to Key On Engine Running (KOER)
DTC refers to Diagnostic Trouble Code (DTC)
DTCs should be diagnosed in the order they are received.
DTC 221
Spark timing error.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 222
Loss of ignition diagnostic monitor signal-right side.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 223
Loss of dual plug inhibit control.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 224
Powertrain control module detected coil 1, 2, 3 or 4 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 225
Knock not sensed during dynamic response test KOER.
KOER Hard Code Go to DG1
DG1 - Check Sensor Voltage Cycling
DTC 226
Ignition diagnostic monitor signal not received.
KOEO Hard Code Go to NC2
NC2 - Service Code 226: IDM Circuit Failure
DTC 232
Powertrain control module detected coil 1, 2, 3 or 4 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 238
Powertrain control module detected coil 4 primary circuit failure.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 241
Ignition control module to powertrain control module ignition diagnostic monitor pulsewidth transmission error.
KOEO Memory Code - Go to Ignition System / Testing and Inspection.
DTC 244
Cylinder Identification circuit fault present when cylinder balance test requested.
KOER Hard Code Go to DR1
DR1 - Will Engine Start
DTC 311
Secondary air injection system inoperative during KOER self-test (bank #1).
KOER Hard Code Go to KC1
KC1 - Visually Inspect Vacuum Hoses
DTC 312
Secondary air injection system misdirected during KOER self-test.
KOER Hard Code Go to KC1
KC1 - Visually Inspect Vacuum Hoses
DTC 313
Secondary air injection system not bypassed during KOER self-test.
KOER Hard Code Go to KC1
KC1 - Visually Inspect Vacuum Hoses
DTC 314
Secondary air injection system system inoperative during KOER self-test (bank #2)
KOER Hard Code Go to KC1
KC1 - Visually Inspect Vacuum Hoses
DTC 326
Exhaust gas recirculation valve pressure sensor circuit voltage lower than expected.
KOER Hard Code Go to DL22
DL22 - Check PFE/DPFE Sensor Pressure Input Hose For Blockage