Test Notes

Normal Operation
The air bag diagnostic monitor measures the resistance between Pin 20 (Circuit 618, P/LG) and Pin 3 (air bag diagnostic monitor reference ground). If the air bag diagnostic monitor measures a difference of more than 2.0 ohms between Pin 20 and Pin 3, it will flash out code 44.

Note that Circuit 618 (P/LG) is grounded to the side of the RH front air bag sensor case and the case of the front air bag sensor is grounded to the vehicle at its mounting point.

Possible Causes
High resistance on Pin 20 (Circuit 618, P/LG) to ground can be caused by:
1. A poor connection due to loose mounting, dirt, or corrosion at the RH front air bag sensor mounting location.
2. An open or damaged wire in Circuit 618 (P/LG) from Pin 20 of the air bag diagnostic monitor harness connector to RH front air bag sensor and bracket.
3. An open circuit inside RH front air bag sensor.