Accelerator Cable

Accelerator Cable:

REMOVE

1. Disconnect the accelerator cable from throttle cam.
2. Loosen locknuts on cable bracket and disconnect cable and rubber grommet from bracket.
3. Disconnect accelerator cable from pedal lever by disconnecting cable retaining clip from lever.
4. Feed cable through bulkhead into engine compartment.
5. Remove accelerator cable by pulling it out of the routing hole in the bulkhead.

INSTALL

1. Feed the accelerator cable through the routing hole in bulkhead.
2. Connect the accelerator cable retaining clip to the pedal lever.
3. Connect the accelerator cable and rubber grommet to the cable bracket.
4. Connect the accelerator to the throttle cam.
5. Tighten the locknuts on the cable bracket.
6. Adjust the accelerator cable deflection.

NOTE: The accelerator cable connects to lower half of throttle cam.