Using Analog VOM

1. Connect pins "TBS" and "GND" at data link connector with jumper wire.
2. Key ON.
3. Output diagnostic trouble codes using the analog VOM.
4. After the first code is repeated, depress the brake pedal 10 times at intervals of less than one (1) second.
5. Key OFF.
6. Disconnect the jumper wire at the data link connector.

NOTES:
- The anti-lock brake warning indicator should illuminate while performing memory cancel.
- When memory cancel operation is completed, the anti-lock brake warning indicator should illuminate for 2-3 seconds, then go OFF.
- After memory cancel, the anti-lock brake control module performs self-diagnosis.
- Memory is not canceled by disconnecting the battery.
- Memory codes cannot be canceled if the following occur:
a. Intervals for depressing the brake pedal exceed one (1) second.
b. Stoplamp miniature bulb or Brake ON/OFF (BOO) switch has malfunctioned.
- If using analog VOM, be sure to remove the jumper wire from the data link connector after all checks and repairs are made.