Using The Passive Restraint Belt System Tester

Description Tool Number

Rotunda Passive Restraint System Tester 007-0034A

The Rotunda Passive Restraint System Tester 007-0034A or equivalent can be used as an aid for performing pinpoint tests or a complete electrical system check. It has numbered jacks for each belt module pin, providing ease in connecting a volt ohm-meter to perform harness checks.

Instructions for using the tester are as follows:

1. Temporarily remove passive restraint belt module.
2. Connect tester to passive restraint module harness connector.
3. Select system A.
4. Switch power ON.
5. Test components as instructed in pinpoint or component tests.
6. Disconnect tester and reinstall belt module.