B5 - Check Harness From Module Connector to B-Pillar Switch

^ Measure resistance between pins of the limit switch harness to pins of the Passive Restraint Module mating connector:

- Driver side -- one limit switch pin to pin 24 (circuit 875, BK/LB), other limit switch pin to pin 18 (circuit 872, LG).

- Passenger side -- one limit switch pin to pin 24 (circuit 875, BK/LB), other limit switch pin to pin 21 (circuit 873, T).

^ Is continuity present?

YES -- Wiring OK.

NO -- Service respective circuit. Install original passive restraint module.