A2 - Check Harness and A-Pillar Limit Switch Open Position

^ Rotate the motor by hand so that the transport is at the A-pillar.

^ Measure resistance between pins of mating connector for the passive restraint module:

- Driver side between pins 5 (circuit 862, BR/Y) and 24 (circuit 875, BK/LB).

- Passenger side between pins 23 (circuit 874, GY) and 24 (circuit 875, BK/LB).

^ Is resistance greater than 500k ohms?

YES -- Switch and wiring OK.

NO -- Go to A4. A4 - Check A-Pillar Limit Switch Open Position