Safety Belt Without Anchor Plate Thread Damage

NOTE: The lap and shoulder safety belts are factory installed in their proper locations. If the belts are removed for any reason, they should be installed using proper service procedures. The anchor bolts and nuts should be hand started and then tightened to the required specification for each mounting position.

1. Remove damaged bolt from anchor reinforcement and discard.
2. Install a new bolt. Tighten to 30-40 Nm (22-30 lb-ft).

Parts Replacement Chart:

3. Install attachment parts in proper sequence. Tighten replacement bolt to 30-40 Nm (22-30 lb-ft). Original parts are to be replaced with service parts. Use original parts, unless otherwise specified in Parts Replacement Chart.