Accelerator Cable

REMOVAL

1. Remove the snow shield from the accelerator cable.

2. Remove the air intake duct assembly.

3. Remove the cable snap-in nylon bushing from the pedal arm.

4. Remove the cable housing from the dash panel by depressing the two vertical snap-in tabs and pushing outward from inside the passenger compartment.

5. Remove the speed control cable from the accelerator cable.

6. Disconnect the accelerator cable from the throttle body lever by
removing cable end slug from cam slug hole.

7. Remove the cable housing to engine mounting bracket retaining screw and remove the cable from the bracket slot.

INSTALLATION

1. Insert the pedal end of the accelerator cable, with the cover in place, through the dash panel and snap the cable housing into the dash panel. Make sure the cable housing retention snaps have engaged into the dash panel.

2. Position the cable housing into the engine mounting bracket, and install and tighten.

3. Connect the cable to the throttle body cam.

4. Install the speed control cable, if equipped.

5. Remove the cable protective cover and snap the cable nylon bushing into the pedal arm.

6. Make sure that the body insulation is properly positioned and not in contact with moving parts of the accelerator cable.

7. Install the air duct assembly.

8. Install the snow shield.