Arming and Disarming
Deactivation ProcedureNOTE: Make sure the ignition switch is in OFF or LOCK position.
1. Disconnect negative battery cable.
2. Disconnect positive battery cable.
3. Wait one minute. This is the time required for backup power supply in diagnostic monitor to deplete its stored energy.
4. Remove four nut and washer assemblies retaining driver air bag module to steering wheel.
5. Disconnect driver air bag connector.
6. Remove the driver air bag. Place the air bag on a bench or other surface with the face of the air bag and trim cover up. away from the surface.
7. Connect Rotunda Air Bag Simulator 105-00010 or equivalent to vehicle harness at top of steering wheel.
8. Connect positive battery cable.
9. Connect negative battery cable.
Reactivation Procedure
WARNING: THE AIR BAG STIMULATOR(S) MUST BE REMOVED AND THE AIR BAG(S) RECONNECTED WHEN THE SYSTEM IS REACTIVATED.
NOTE: Make sure the ignition switch is in OFF or LOCK position.
1. Disconnect negative battery cable.
2. Disconnect positive battery cable.
3. Wait one minute for backup power supply to deplete stored energy.
4. Remove Rotunda Air Bag Simulator 105-00010 or equivalent from vehicle harness connector at top of steering column. Reconnect driver air bag connector. Position driver air bag on steering wheel and secure with four nut and washer assemblies (10 mm (0.39 inch). Tighten nut and washer assemblies to 2.7-3.7 Nm (24-33 lb-in).
5. Connect positive battery cable.
6. Connect negative battery cable.
7. Proveout system.