B1 - Check Harness and B-Pillar Limit Switch Closed Position

^ Remove access cover over the motor of the side to be checked.

^ Rotate the motor by hand so that the transport is somewhere in between both ends of track but at least three inches from either end of track.

^ With Rotunda Digital Multimeter 105-00050 or equivalent, measure resistance between pins of mating connector for passive restraint module:

- Driver side between pins 18 (circuit 872, LG) and 24 (circuit 875, BK/LB).

- Passenger side between pins 21 (circuit 873, T) and 24 (circuit 875, BK/LB).

^ Is resistance greater than 10 ohms?

YES -- Go to B3. B3 - Check B-Pillar Limit Switch Closed Position

NO -- Go to B2. B2 - Check Harness and B-Pillar Limit Switch Open Position