With Floor Shifter

NOTE: Whenever the transmission shift cable and bracket is removed from the cable retaining brackets for any reason, the cable must be replaced.

NOTE: Whenever a steering column, engine, or transaxle removal is required, do not remove the transmission shift cable and bracket from the retaining brackets. The bracket must be removed with the cable attached.

REMOVAL
1. Remove the console. Disconnect the transmission shift cable and bracket and remove the shift control selector lever and housing.
2. Pull back the floor carpet.

Transmission Shift Cable And Bracket:

3. Remove the cable bracket to dash panel retaining screw.
4. Disengage the rubber grommet from the front floor pan by pushing it toward the passenger compartment.

Transmission Shift Cable And Bracket Removal:

5. Remove the retaining nut and the transmission shift cable and bracket from the transaxle manual control lever.
6. Remove the cable retaining clip from the cable bracket on the transaxle.
7. Remove the transmission shift cable and bracket from the bracket.

Ignition/shifter Interlock Assembly:

8. Pull the transmission shift cable and bracket through the front floor pan into the passenger compartment.

INSTALLATION
1. From inside the passenger compartment, feed the round end of transmission shift cable and bracket through the front floor pan.
2. Press the rubber boot on the transmission shift cable and bracket into the body panel opening. Install the cable bracket and the floor carpet.
3. Install the bushing and the transmission shift cable and bracket into the snap retainer on the shift control selector lever and housing.
4. Position the transmission shift cable and bracket in the shift control selector lever and housing. Install the retaining screws.
5. Install the shift control selector lever and housing.
6. Place the selector lever in the OVERDRIVE position against the rearward stop. The selector lever must be held in the rearward position while attaching the other end of the transmission shift cable and bracket. Position the cable into the cable bracket on the transaxle and install the retainer clip.
7. Attach the transmission shift cable and bracket to the transaxle lever and install the retaining nut.
8. Shift the transaxle lever into the OVERDRIVE position, the second detent from the full rearward position.
9. Place the cable end on the transaxle manual lever stud, using care to align the flats on the stud with the slot in the transmission shift cable and bracket. Start the retaining nut.
10. Make sure the selector lever has not moved from the OVERDRIVE detent, then tighten the nut.
11. Check the transaxle operation in each selector lever detent position. Ensure the park mechanism and park/neutral position switch function properly.