Removal and Installation

Removal

1. Disconnect battery ground cable.

2. Remove engine damper mounting body bracket.

3. Remove power steering drive belt.

4. Raise vehicle on hoist.

5. Remove right front wheel and tire assembly.

6. Position jack under engine. Remove right rear engine mount.

7. Remove power steering pump pulley.

8. Position drain pan. Remove power steering pressure hose and power steering return hose from power steering pump.

9. Remove four power steering pump retaining bolts (three in front, one in rear) and remove power steering pump.

Installation

1. Position power steering pump and install retaining bolts. Tighten retaining bolts to 20-32.5 N-m (15-24 lb-ft).

2. Install power steering pressure hose and power steering return hose to power steering pump. Remove drain pan.

3. Install power steering pump pulley.

4. Install right rear engine mount and remove jack.

5. Install right front wheel and tire assembly. Tighten wheel hub bolt nuts to 115-142 N-m (85-105 lb-ft).

6. Lower vehicle.

7. Install drive belt to power steering pump pulley.

8. Install engine damper mounting body bracket.

9. Connect battery ground cable.

10. Fill power steering oil reservoir to proper level.