Auxiliary Seat Belts - Wagon

Outboard:

REMOVAL
1. Remove nut to remove outboard auxiliary belt and buckle assembly.
2. Remove rear seat back.
3. Remove three screws retaining stowage compartment door and hinge.
4. Remove stowage compartment door and hinge. Reach between floorpan and load floor and remove the nut to pull out the retractor.

INSTALLATION
1. To install, reverse removal procedure.
2. Tighten retractor retaining nuts to 60-90 Nm (44-66 lb ft). Cycle retractor several times to ensure proper operation of retractor. Make sure safety belt is not twisted.