Wiper Control Switch

Wiper Control Switch


Intermittent

The intermittent wiper control switch, located in the knob at the end of the turn signal lever, operates as follows:

- The ignition switch lock cylinder must be in the RUN position to operate wiper.

- In addition to O, there are two fixed wiper speed positions, LO and HI, as well as an interval position.

- Positions are selected by rotating the knob actuator relative to the turn signal lever.

- If interval position is selected, the time between wiper cycles will decrease as the knob is rotated away from the OFF position and increase as the knob is rotated toward the OFF position.

- The time interval between wipes will vary depending on the knob's position from OFF.

- Wiper speed for interval wiper operation is fixed at the LO speed setting.