High Beam/Flash-to-Pass Switch

High Beam/Flash-To-Pass Switch

The headlamp dimmer switch and the flash-to-pass feature, also operated by the turn signal lever, operate as follows:

- Select high beam by moving the turn signal lever away from the driver to the stop.

- Release the lever to maintain high beams.

- Select low beam by moving the turn signal lever toward driver from high beam position.

- Release the lever to maintain low beams.

- Pull the lever gently toward driver to operate flash-to-pass feature.

- Release lever to return to low beam position.

- Using the flash-to-pass feature without the headlamp bulbs on will turn on the high beams until the turn signal lever is released.

- Using the flash-to-pass feature with the headlamp bulbs on will keep the low and high beams on until the turn signal lever is released.

NOTE: Excessive force used to hold the turn signal lever in the flash-to-pass function followed by quick release may result in incorrect headlamp bulb dimmer selection of high beam. The driver must be cautioned to avoid this condition.