Initial Inspection and Diagnostic Overview

INITIAL SEAT BELT SYSTEM INSPECTION
1. Verify the customer's concern by operating the active restraint system to duplicate the condition.
2. Inspect to determine if one of the following mechanical or electrical concerns apply:

Mechanical
- Inspect safety belt webbing for integrity.

Electrical
- Burned out fuse.
- Bare, damaged or disconnected wire.
- Connector not tightly engaged.
- Safety belt warning indicator lamp burned out or damaged.

3. If inspection reveals obvious concerns that can be readily identified, service as required.
4. If the concern remains after the inspection, determine the symptoms and proceed to the Symptom Chart.Symptom Related Diagnostic Procedures