Test Notes

NORMAL OPERATION
The voltage at Pin 18 (Circuit 619, PK/W) is approximately 10 volts (+/- 1 volt). Circuit 619 is connected to Circuit 625 (Y/LG) inside center radiator primary crash sensor. Therefore, the voltage at Pin 6 should be the same as the voltage at Pin 18. If the voltage at Pin 6 is lower than the voltage at Pin 18, the air bag diagnostic monitor will flash code 42.


POSSIBLE CAUSES

Low Voltage On Pin 6 Can Be Caused By:

1. An open circuit in the wiring harness in either Circuit 619 (PK/W) or Circuit 625 (Y/LG).

2. An open circuit in center radiator primary crash sensor across the PK/W and Y/LG wires.