Engine Mount: Service and Repair
LEFTHAND INSULATOR & SUPPORT1. Raise and support vehicle.
2. Remove lefthand front tire and wheel assembly, then support transaxle using suitable jack and block of wood.
Engine Mounts:
3. Remove insulator to support attaching nuts.
4. Remove insulator to frame through bolts, then raise transaxle enough to unload insulator.
5. Remove support assembly to transaxle attaching bolts.
6. Rotate support assembly counterclockwise to remove from upper stud.
7. Reverse procedure to install.
RIGHTHAND FRONT NO. 2 & RIGHTHAND REAR NO. 3
1. Raise and support vehicle.
2. Place jack and wood block under engine block.
3. Remove nuts retaining righthand front and righthand rear insulators to frame.
4. Raise engine enough to unload insulator, then remove through bolts and engine mounts.
6. Reverse procedure to install.