Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor Assembly:

REMOVE

1. Disconnect negative battery cable.

2. Remove serpentine belt.

3. Raise vehicle and support with jackstands.

4. Disconnect Crankshaft Position (CKP) sensor and A/C compressor electrical connectors from the engine wiring harness.

5. Discharge the A/C system and remove the A/C compressor.

6. Remove the CKP sensor retaining screw and sensor.


INSTALL

1. Make sure the CKP sensor mounting surface is clean and sensor O-ring is in proper location on the assembly.

2. Position CKP sensor assembly and install the retaining screw. Tighten to 8-12 Nm (71-106 in lb).

CAUTION: Do not overtighten the screw.

3. Install the A/C compressor. Evacuate and recharge the A/C system.

4. Properly route the engine wiring harness and connect the electrical connectors to the A/C compressor and crankshaft sensor.

5. Lower the vehicle.

6. Install the serpentine belt.

7. Connect the negative battery cable.