TG96 - Check For DTC 0707

DTC 0707 indicates the MLP circuit voltage was below the allowed minimum voltage.

Possible Causes:
- Damaged MLP sensor.
- Short to GND in MLP harness SIG circuit.
- Open in MLP harness SIG circuit.
- Damaged PCM.

- Did DTC 0707 repeat during the drive cycle test?

YES -- GO to TG97. TG97 - Check Continuity of the MLP Harness SIG Circuit

NO -- GO to TG99. TG99 - DTC 0708 Was Generated During the Drive Cycle Test