TG94 - Check For DTC 0705 Generated With DTC 0708

DTC 0708 indicates the MLP sensor circuit voltage was above the allowed maximum value.

Possible causes:
- Damaged MLP sensor.
- Open in MLP harness SIG RTN circuit.
- Short to PWR in MLP harness SIG circuit.
- Damaged PCM.

- Did DTC 0705 repeat with DTC 0708 during the drive cycle test?

YES -- GO to TG99. TG99 - DTC 0708 Was Generated During the Drive Cycle Test

NO -- GO to TG95. TG95 - Check MLP Sensor Alignment