DA92 - Check PCM and Vehicle Harness Connectors

- Key Off.

- Disconnect PCM.

- Disconnect sensor connector. Inspect for spread terminals, pushed out pins and loose or crimped wires.

- Are connectors and terminals OK?

YES -- Fault is not present at this time. Complete PCM reset to clear DTCs. Clearing Diagnostic Trouble Codes

Rerun quick test. Diagnostic Subroutines (DSR) - Extracting Codes

For Continuous DTCs 1112 and 1117, COMPLETE Comprehensive Component Monitor Drive Cycle. Monitors, Trips, Drive Cycles and Readiness Codes

NO -- SERVICE as necessary. Complete PCM reset to clear DTCs. Clearing Diagnostic Trouble Codes

Rerun quick test. Diagnostic Subroutines (DSR) - Extracting Codes

For Continuous DTCs 1112 or 1117, COMPLETE Comprehensive Component Monitor Drive Cycle. Monitors, Trips, Drive Cycles and Readiness Codes