Removal and Installation

1. Raise and support vehicle, then remove wheel and tire assembly.
2. Note rotor to hub position indicated by paint marks on one of the studs and rotor. Reassemble with paint marks aligned to ensure lowest mounted total indicated runout of rotor.
3. Remove disc brake caliper, rear disc brake rotor, and wheel hub assemblies.
4. Using suitable three-jaw puller, remove front brake anti-lock sensor indicator toothed wheel from wheel hub.
5. Reverse procedure to install, noting the following:
a. Ensure sensor indicator toothed wheel is pressed on straight.
b. Ensure paint mark on rotor aligns with paint mark on wheel stud to ensure lowest mounted total indicated runout of disc brake rotor.