Instrument Panel - Defroster Grill Finish Panel

REMOVAL and INSTALLATION

NOTE: Protect the instrument panel surface during this procedure.

1. Using putty knife or similar tool, insert under the LH or RH corner of the instrument panel upper finish panel and pry up the instrument panel upper finish panel to release one snap clip.
2. Unsnap the remaining four clips pulling up by hand, working toward the opposite side of the vehicle.
3. Disconnect the A/C sunload sensor wiring connector.
4. To install, make sure the five locator tabs on the front of the instrument panel upper finish panel are installed in the slots then press down on the instrument panel upper finish panel to snap in place.