Rear

1. Remove rear wheel and tire assemblies.
2. Remove rear disc brake caliper and rotor assemblies.
3. Loosen trailing arm attaching bolt, then loosen spindle to shock absorber attaching bolts.
4. Remove trailing arm and spindle attaching bolts.
5. Mark alignment on strut rubber mounting bracket.
6. Inside trunk, remove upper strut attaching nuts.
7. Compress coil spring using tool T81P-5310-A or equivalent.
8. With spring compressed, remove strut rod attaching nut, rubber mounting bracket, spring upper and lower seat, then the rubber spring seat.
9. Release coil spring and remove spring compressor tool.
10. Remove coil spring, dust boot and rebound bumpers.
11. Reverse procedure to install.