Front Retractor and Harness Assembly

Removal
1. Remove interior trim to gain access to retractor.
2. Remove bolt, washer and retractor.
3. Remove cover and remove bolt, sash guide pivot, spacer and lockwasher at door opening.
4. Remove bolt, spring washer anchor, spacer and lockwasher.
5. Remove retractor and harness assembly.

Installation

CAUTION: Use care to prevent cross threading the safety belt bolts during installation.

1. Install retractor and harness assembly with washer and bolt. Tighten bolt to 25-27 N.m (18-20 lb-ft).
2. Install sash guide pivot with lockwasher, spacer, and bolt. Tighten bolt to 25-27 N.m (18-20 lb-ft).
3. Install anchor with lockwasher, spacer, spring washer and bolt. Tighten bolt to 25-27 N.m (18-20 lb-ft).
4. Install interior trim.
5. Verify proper operation of harness assembly.