Accelerator Pedal: Service and Repair

Throttle Cable R&R

Throttle Cable:

Accelerator Pedal And Linkage:

REMOVE

1. Remove the cable end from the throttle body.

2. Remove the adjusting nut at the cable housing brace located near the throttle body.

3. Remove cable routing bracket retaining bolt.

4. Squeeze the lock tabs and remove the cable end from the pedal assembly.

5. Squeeze lock tabs securing cable housing to dash panel and remove the cable assembly.

NOTE: Prior to installation, inspect lock tabs which secure cable housing to dash panel. If lock tabs are damaged, replace cable.

Install

1. Position cable housing into hole in dash panel and snap it into place.

2. Install cable end onto accelerator pedal and snap it into place.

3. Install cable routing bracket and retaining bolt.

4. Install cable into cable housing brace near throttle body and install locknut finger-tight.

4. Install cable end onto throttle linkage.

5. Adjust pedal free play and wide-open throttle position as outlined in Adjustments. Adjustments