Coolant Supply Hose

REMOVAL

1. Disconnect negative battery cable.
2. Drain cooling system.
3. Remove two screws retaining air cleaner duct tube, loosen clamp at turbocharger and position tube out of the way.
4. Disconnect coolant hose from engine block.
5 Raise vehicle.
6. Disconnect coolant hose from turbocharger fitting.
7. If necessary, remove bolt and brass sealing washers from turbocharger.

INSTALLATION

1. If fitting was removed, install bolt through fitting with a brass sealing washer on each side of fitting.
2. Install fitting onto turbocharger and tighten bolt securely.
3. Route hose into position and connect one end to turbocharger fitting and secure with clamp.
4. Lower vehicle.
5 Connect coolant hose to engine block and secure with clamp.
6. Install air cleaner duct to turbocharger and secure with clamp.
7. Install two retaining bolts into air cleaner duct tube.
8. Connect negative battery cable.
9. Refill cooling system.
10. Start engine and check for leaks.