With Scan Tool

1. Deactivate self-test by unlatching the center button on the Super Star II tester and turn the tester OFF.

2. Connect a Rotunda 88 Digital Multimeter 105-00053, or equivalent as a tachometer.

3. Run engine at 2000 rpm for three minutes.

4. Turn the Super Star II tester ON.

5. Latch center button on Super Star II tester.

6. Turn engine OFF.

7. Start the engine. Run engine at idle.

8. Activate Self Test by unlatching and relatching Super Star II tester.

9. Record service codes.

If no codes and sent here from Key On Engine Off (KOEO) Self Test, Switch Monitor Test

If no codes and sent here from Erase and Retest, Scan Tool Testing and Procedures

If codes are present, refer to Service Code Chart below.

CODE AFFECTED CIRCUIT PINPOINT TEST

02 Crankshaft Position Sensor CKP CKP - Crankshaft Position Sensor

03 Cylinder Identification Sensor CID CID - Cylinder Identification Sensor

08 Air Flow Meter VAF VAF - Vane Air Flow Sensor

09 Engine Coolant Temperature ECT ECT - Engine Coolant Temperature Sensor

10 Intake Air Temperature IAT IAT - Intake Air Temperature Sensor

12 Throttle Position Sensor TP TP - Throttle Position Sensor

14 Barometric Pressure Sensor BARO BARO - Barometric Pressure Sensor

15 Oxygen Sensor O2S O2S - Oxygen Sensor

17 Oxygen Sensor O2S O2S - Oxygen Sensor

25 Solenoid Controlled By Ground SCG SCG - Solenoid Controlled By Ground

26 Solenoid Controlled By Ground SCG SCG - Solenoid Controlled By Ground

34 Solenoid Controlled By Ground SCG SCG - Solenoid Controlled By Ground

41 Solenoid Controlled By Ground SCG SCG - Solenoid Controlled By Ground

CODES NOT LISTED PGC PGC - Power and Ground Connections