Throttle Valve Cable/Linkage: Adjustments

ADJUST

NOTE: The Throttle Valve (TV) linkage adjustment is pre-set at the factory. Any time the engine, transaxle, or throttle linkage components are removed, it is recommended that the TV linkage adjustment be reset after component installation or replacement.

1. Remove splash shield from cable retainer bracket.
2. Loosen trunnion bolt on TV rod.
3. Install plastic clip using TV Linkage Adjustment tool No. T91P-7000-A or equivalent to bottom of TV rod. Ensure clip keeps rod from telescoping.
4. Ensure TV return spring is connected between TV rod and retaining bracket, to hold transaxle TV lever at its idle position.
5. Ensure throttle lever is resting on throttle return control screw, then tighten trunnion bolt on TV rod.
6. Remove TV linkage adjustment tool (plastic clip) from TV rod.
7. Install splash shield. Check for proper operation.