Front Center Sensor

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE POSITIVE BATTERY CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

NOTE: To service stripped front outboard sensor retaining screws, replace screws with 6.0 mm self-tapping screws (part no. N806327-S190). Tighten to 2.7-3.7 Nm (24-32 lb-in).

1. Disconnect positive battery cable.
2. Remove air induction resonator.
3. Disconnect center front sensor electrical connector.
4. Remove three screws retaining center front sensor to radiator support. Remove sensor from vehicle.





Installation
1. Position front center sensor with arrow on top pointing toward front of vehicle and secure to radiator support with three retaining screws. Tighten screws to 10.2-13.8 Nm (91-122 lb-in).
2. Connect front center sensor wire lead connector to wiring assembly connector.
3. Install air induction resonator.
4. Connect positive battery cable.
5. Verify air bag indicator.