FREE REPAIR MANUALS & LABOR GUIDES 1982-2013 Vehicles
Courtesy of Operation CHARM: Car repair manuals for everyone.

Wagon







Removal and Installation
1. Remove rear seat cushion.
2. Remove rear seat back.
3. Remove buckle end anchor plate nuts and remove buckle end belts.
4. Remove roof side inner rear moulding on driver's or passenger's side.
5. Remove bolt in sling assembly.
6. Remove quarter trim panel.
7. Remove safety belt anchor plate-to-sill bolt.
8. Remove safety belt through slot near sill.
9. Snap out bezel in quarter trim panel.
10. Remove safety belt assembly through bezel opening.
11. Remove safety belt retractor bolt.
12. Remove outboard safety belt assembly from vehicle.
13. Repeat procedure on opposite side.
14. To install, reverse removal procedure. Cycle retractor to check for proper operation. Ensure safety belt is not twisted.

NOTE: Be sure to tighten all retaining bolts to 30-40 N.m (23-29 lb-ft).