Combination Switch: Service and Repair

Switch, Multi-Function






Removal

1. Disconnect battery ground cable.

2. Tilt column to lowest position and remove tilt lever.

3. Remove ignition lock cylinder.

4. Remove shroud screws and remove upper and lower shroud.

5. Remove two self-tapping screws that attach multi-function switch to steering column casting. Disengage switch from casting.

6. Disconnect the two electrical connectors.

Installation

1. Install two electrical connectors to full engagement.

2. Align multi-function switch mounting holes with corresponding holes in the steering column casting. Install two self-tapping screws making sure to start the screws in the previously tapped holes. Tighten to 2-3 N-m (17-26 lb-in).

3. Install upper and lower steering column shroud with screws.

4. Install ignition lock cylinder.

5. Attach tilt lever.

6. Connect battery ground cable.

7. Check steering column and switch for proper operation.