Instrument Panel Circuit Board: Service and Repair

REMOVAL
1. Remove instrument cluster.
2. Remove low fuel warning assembly.
3. Remove all bulb and socket assemblies by twisting counterclockwise.
4. Remove speedometer and gauges.
5. Remove clips using long nose pliers. Squeeze both ends of clip equally so that locking ears will slide through clip opening in backplate. Push clip through opening.

CAUTION: Do not overbend clips as they may break.

6. After all clips are removed, printed circuit can be removed.

INSTALLATION
1. Position printed circuit on backplate and install clips by bending tabs on clips with fingers. Push clip into clip opening until locking ears are locked into backplate.

NOTE: An audible click will be heard when clips are locked into position.

2. Install speedometer and gauges.
3. Install all bulb and socket assemblies into backplate by twisting clockwise.
4. Install low fuel warning assembly.
5. Install instrument cluster.