Blower Motor Speed Control

REMOVAL
1. Disengage the glove compartment door tabs and allow the door to hang by the hinge.

Blower Motor Speed Controller:

2. Working through the glove compartment opening, disconnect the electrical snap-lock connector and the aspirator hose at the blower motor controller. Also, disconnect the snap-lock connector from its mounting bracket.

EATC Evaporator Case Assembly - Disassembled View:

3. Remove the two screws retaining the blower controller to the evaporator case and remove the controller. Do not touch the fins of the controller until it has had sufficient time to cool.

INSTALLATION
1. Position the blower controller on the evaporator case and install the two retaining screws.
2. Connect the wire connector and the aspirator hose to the blower controller. Install the connector on the mounting bracket.
3. Close the glove compartment door.
4. Check the system for proper operation.