System Reactivation Procedures

1. Disconnect positive battery cable.
2. Wait one minute for backup power supply to deplete stored energy.






3. Remove air bag simulator from vehicle harness connector at top of steering column. Reconnect driver air bag connector. Position driver air bag on steering wheel and secure with four nut and washer assemblies (10 mm). Tighten nut and washer assemblies to 2.7-3.7 Nm (24-32 in lbs).

WARNING: The air bag simulator(s) must be removed and the air bag(s) reconnected when the system is reactivated.

4. If vehicle is equipped with passenger air bag, remove air bag simulator from vehicle harness connector. Reconnect passenger air bag.
5. Connect positive battery cable.
6. Prove out system.