Displaying and Reading Trouble Codes
On-Board Diagnostics Tools Required:- Rotunda SUPER STAR II Tester 007-0041 B
NOTE: Ford DOES NOT provide procedures to retrieve trouble codes without the Super Star II tester.
On-Board Diagnostic Procedure
The anti-lock brake/traction assist system has self-diagnostic capabilities, however, the module as received from manufacturing is equipped with a stored Error Code (61). This will affect the service procedure.
The error codes can be retrieved from the ABS module in the following manner.
1. Connect SUPER STAR tester to connector located in engine compartment.
2. Turn on SUPER STAR II tester and latch button down in TEST position.
3. GTurn ignition switch to RUN position.
4. Read first code output, after approximately 15 seconds the next code will be output. Leave button latched until all codes are output.
NOTE: Make sure that all codes are written down.
The diagnostic procedure should be as follows providing that the CHECK ANTI-LOCK BRAKE indicator stays on all the time or flashes intermittently.
NOTE: If the BRAKE warning indicator is on or intermittently comes on, refer to the warning indicator symptom chart.Symptom Related Diagnostic Procedures
1. If the first code received is 18,19 or in the 20s and no other code is received, service the indicated component. No other codes can be output if a 18,19 or 20's DTC exists. After servicing the indicated 18,19 or 20s code, repeat the procedure for retrieving error codes.
NOTE: If there are more codes stored in the ABS module memory, no codes will erase until all codes have been output by the SUPER STAR II tester, all malfunctions have been serviced and the vehicle is driven about 40 Km/h (25 mph). This means that if a 18,19 or 20s code originally existed and was serviced, it can be ignored when running the on-board diagnostic the second time.
2. If a Code 61 is received with any other code, ignore the Code 61 and service the other indicated malfunctions. If after correcting all other indicated malfunctions, the CHECK ANTI-LOCK BRAKE indicator is still on, service the FLS circuit.
3. If a Code 61 is received and no other DTCs are received, service the FLS circuit.
4. If no code, or only a Code 10 is received, use the Anti-Lock Quick Check Sheet in the diagnostic manual since some possibilities are not recognized and retained in the ABS module memory.