Removal and Replacement

REMOVAL

1. Disconnect Idle Air Control (IAC) valve assembly connector from the wiring harness.

2. Remove two IAC valve retaining screws.

3. Remove IAC valve and gasket.

Air Bypass Valve:

INSTALLATION

1. Ensure that both throttle body and IAC valve gasket surfaces are clean.

NOTE: If scraping is necessary, be careful not to damage IAC valve or throttle body gasket surfaces, or drop material into throttle body.

2. Install gasket on throttle body surface and mount IAC valve assembly, securing it with two retaining screws. Tighten to 8-11 Nm (71-97 lb in).

3. Connect electrical connector for IAC valve.