2-3 Accumulator Piston

REMOVAL
1. Remove valve body.
2. Compress 2-3 accumulator piston cover, then remove snap ring retainer.
3. Release cover slowly, then remove piston cover, return spring, and piston.

NOTE: Some models do not use a spring.

4. Remove seal from 2-3 accumulator cover and piston and inspect for damage and wear.

INSTALLATION
1. Install new seals on 2-3 accumulator cover, if necessary. Lubricate cover pocket of case with transmission fluid.
2. Install 2-3 accumulator piston and return spring into case, then the cover.
3. Compress cover using suitable tool, then install snap ring.

NOTE: Ensure cover is reseated snugly against snap ring.

4. Install valve body, filter, pan, and gasket. Refill transmission pan to proper fluid level.