Front Center

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY POSITIVE CABLE MUST BE DISCONNECTED PRIOR TO SERVICING ANY SYSTEM COMPONENTS.





Removal
1. Disconnect positive battery cable and wait one minute for backup power supply energy to be depleted.
2. Remove front bumper assembly.
3. Disconnect center radiator sensor connector from wiring harness connector.
4. Remove the two bolts retaining the sensor to the radiator support. Remove the sensor from the vehicle.

Installation
1. Position the sensor with the arrow on top pointing toward the front of the vehicle and secure to the radiator support with two bolts. lighten bolts to 9-12 N.m (7-9 lb-ft).
2. Connect sensor lead to the wiring harness connector.
3. Install front bumper assembly.
4. Connect positive battery ground cable.
5. Prove out air bag system.