Installation

Rear Stabilizer Bar Installation

1. Position the grommets onto the stabilizer bar and align the grommets to the positions painted on the bar.

2. Position the stabilizer bar to the rear suspension crossmember of the vehicle and secure it in place with the straps and bolts.

3. Tighten the stabilizer bar-to-rear suspension crossmember bolts to 43-59 N.m (32-43 lb-ft).

4. Install the stabilizer bolts, washers, bushings, grommets, sleeves and nuts.

5. Tighten the stabilizer nuts so that 16.2-l7mm (0.64-0.72 inch) of thread is exposed at the end of the bolt.

6. Lower the vehicle.