Automatic Transaxle

1. Disconnect electrical connector from throttle position sensor.
2. Connect volt-ohmmeter to IDL and E terminals on sensor.

Throttle Position (TP) Sensor:

3. Loosen sensor mounting screws.

Throttle Position (TP) Sensor:

4. Insert 0.250 mm (0.010 in) feeler gauge between throttle stop screw and stop lever.
5. Rotate sensor clockwise approximately 30 degrees, then rotate counterclockwise until continuity exists.
6. Replace 0.250 mm (0.010 in) feeler gauge with 0.40 mm (0.0160 in) feeler gauge and insert it between throttle stop screw and stop lever.
7. Verify continuity no longer exists.

NOTE: If there is still continuity, repeat steps 4 through 7.

8. Tighten sensor mounting screws while making sure not to move sensor from its position.

Throttle Position (TP) Sensor:

9. Open throttle plate to wide open throttle position several times and verify that resistance between E and VT terminals is approximately 5K ohms.