Idle Speed/Throttle Actuator - Electronic: Service and Repair

Air Bypass Valve:

REMOVAL

- Disconnect electrical connector from air bypass valve assembly.

- Remove the two bypass valve retaining bolts.

- Remove air bypass valve and gasket.

INSTALLATION

- Clean gasket mating surfaces.
NOTE: If scraping is necessary, DO NOT damage air bypass valve or intake manifold gasket surfaces. Avoid dropping gasket material into manifold passages.

- Install a new gasket and air bypass valve.

- Install retaining screws and tighten to 6-8.8 ft lb (8-12 Nm).

- Connect electrical connector to air bypass valve assembly.