Front Sensors and Brackets

Removal





WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE AND THE BATTERY BACKUP MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.


1. Raise the headlamps by using the service switch. If servicing LH sensor, remove LH headlamp bezel and splash shield.
2. Disconnect battery ground cable and battery backup power supply.
3. Remove electrical connector retaining clip from the apron under headlamp.
4. Disconnect the electrical connector.
5. Remove the two bolts retaining the sensor and remove the sensor.

Installation
1. Position the sensor in the vehicle, ensuring that the arrow faces to the front of the vehicle. Install sensor retaining bolts and tighten to 20-25 N.m (15-18 lb-ft).
2. Connect the sensor lead to the wiring harness connector.
3. Install the connector retaining clip into the hole in the apron. If servicing LH sensor, install LH headlamp splash shield and bezel.
4. Connect battery ground cable and battery backup power supply.
5. Lower the head lamps.
6. Verify air bag indicator lamp.