Starts, But Stalls

Engine starts but stalls when load is placed on the engine (A/C clutch engaged or transmission shifted into drive or reverse).

POSSIBLE CAUSE ACTION

EGR malfunction,
EGR valve plunger loose or sticking,
flange gasket leaking,
solenoid valve malfunction
1. Check EGR system
If OK, proceed to step 2
2. Check EGR electronic controls.



Hot air tube not connected
to air cleaner - air damper
door binding or not open Check the inlet air temperature system



Initial timing incorrect Check Ignition Timing



Idle speed too low Check operation of any idle speed controlling device. Check and adjust idle speed



Poor or contaminated fuel Recommend higher grade fuel