Oil Line: Service and Repair

REMOVAL

1. Disconnect negative battery cable.
2. Remove two screws retaining air cleaner duct tube, loosen clamp at turbocharger and position duct tube out of the way.
3. Remove oil line fitting at turbocharger.
4. Remove bolt and brass sealing washer from oil line at engine block.
5. Remove oil supply line.

INSTALLATION

1. Insert bolt through oil line, with a brass washer on each side of fitting.
2. Carefully position oil line into vehicle and hand-start bolt into engine block.
3. Connect oil line to turbocharger and finger-tighten.
4. Tighten oil line bolt to 104 - 156 in lb (12 - 18 Nm).

Oil Line Installation:

5. Tighten oil line fitting to 12 - 17 ft lb (16 - 24 Nm).
6. Install air cleaner duct tube to turbocharger and secure with clamp. Install two retaining bolts.
7. Connect negative battery cable.
8. Start engine and check for leaks.