Front Lap Belt Retractor

REMOVAL






1. Remove the retractor bezel mounting screws.
2. Pull the lap belt out of the retractor bezel and remove the bezel.
3. Position the floor carpeting to gain access to the retractor mounting bolts.






4. Remove the retractor mounting bolts and remove the front lap belt retractor.

INSTALLATION
1. Place the retractor into its mounting position and install the mounting bolts. Tighten the bolts to 38-78 Nm (28-58 ft lbs).
2. Place the floor carpeting into its original position.
3. Place the lap belt through the eyelet in the retractor bezel, then place the bezel into its mounting position.
4. Install the retractor bezel mounting screws.